The things that are required to apply grip tape to your longboard contain: Skateboard Deck, Skateboard Grip tape, File, which includes a Razor Blade or Box Cutter. Listed here would be the step to effectively apply them: sector 9 completes • Remove all traces of visible paper on the back of the grip tape. This will leave you the sticky area. •You need to use the piece of the backing paper to hold the surface of the tape to protect your hands from the sticky area. •Slice the grip tape slightly greater than the board by figuring out its midpoint. Let the grip tape dangle a bit in the middle area. That is to make sure that the tape about the board will stick during the middle firstly. Once the tape has stuck on the middle, you need to make sure that you meticulously stick on the edges and this has to be carried out from the middle onwards. Remember that the grip tape is quite sticky, thus handle it with great care. loaded longboards •To be able to scratch the outer region for the deck of your longboard, you should have to utilize a metal file or even the metal place on the screwdriver. You need to make sure that all the grains are removed. To establish the boards’ limits, you require to make certain that the white line is visible inside the grip tape. •You can sue the razor blade or cutter to remove all the excess grip tape by positioning it on a 45 degree angle and cut from the base upwards. Ensure that you start the process at the nose or tail. Once you’ve completed this, transfer along the white outline and go the blade along the sides to cut additional grip tapes. complete •In order to level the uneven edges, rush a metal file approximately within the edges of the longboard.•Lastly, make use of a screwdriver in order to push holes all the way through the grip tape wherever the trucks would be accumulated.